LED car lamp resistor - 5W 56 Ohm - 12V

5W 56 Ohm LED resistor - for LED car lighting - 12V

Have you replaced the bulbs in your car with LEDs and now get an error message on your dashboard? Or is your LED turn signal suddenly flashing much too fast? This LED resistor^? will solve that. The resistor is 5 Watts, 56 Ohms and is intended for the 12V circuit^? of your car.

Why an error message with LEDs?

An LED bulb consumes much less current than a light bulb. Many cars check whether enough current is flowing through a bulb. If it is too low, the car thinks the bulb is broken. You will then get a message, or your turn signal will flash faster. The resistor allows extra current to flow, so the car sees a 'working bulb' again.

What is included?

• Resistance value^?: 56 Ohms
• Power: 5 Watts
• Suitable for 12 Volts
• You receive 1 resistor with 2 cable connectors.

Installation

You connect the resistor in parallel^? with the LED bulb: one wire to the positive and one to the negative of the bulb connection. Use the included cable connectors to connect the resistor to the existing wires. A resistor converts current into heat and can therefore get hot. Therefore, attach it to metal and not against plastic or cables. Always turn off the ignition when connecting.

Order this LED resistor and drive again without error messages. Also discover our other LED resistors.